Questions, answered

Nokka parts are designed for Tikka T3, T3x, and T1x OEM stocks where the specific product fitment line says so.

Always check the product page before buying. If you are unsure whether the issue is cheek height, length of pull, or scope position, use the fit checklist first.

The standard LOP kit is designed around Tikka factory-stock setups. Aftermarket recoil pads vary, so send us a clear photo of your stock and pad before ordering and we will confirm the fit and fastening path.

The Drop Comb Cheek Riser is adjustable through the range most scoped setups need, including medium and high rings. Match your comb height to your scope height — our cheek weld guide walks through how.

Set eye relief with your actual scope and rings first. If your head lifts or rolls to see through the scope, start with cheek height. If you are stretching or cramped after eye relief is right, check length of pull.

The fit checklist walks through that order before you choose a part.

Run the fit checklist again before choosing another part. A scope, ring, rail, or eye-relief change can move the problem between scope position, cheek height, and length of pull.

Use the fit checklist with the actual scope and rings fitted.

Set eye relief first. If the stock still feels too long, do not add LOP spacers yet.

Start with setup notes first: rifle model, stock, scope, ring/base setup, shooting position, and what feels off. We will ask for photos if they are needed.

Each product page lists fitment, included items, setup notes, and current shipping information. If you are still choosing, start with the fit checklist.

The Performance Kit includes the Drop Comb Cheek Riser and the LOP Spacer Kit. Choose it when cheek height and length of pull both need work; if only one issue shows up, buy that part on its own.

No. Direct sales are paused while exact trigger-mechanism compatibility and measured pull-weight compliance are validated against current Tikka guidance. No compatible application or post-install result is currently published.

If you already have the part, do not continue using it without qualified-gunsmith verification. The current Tikka manual specifies 2.5–4 lb and says not to reduce trigger weight below 2.5 lb.

The cheek riser and LOP spacer kits are designed for simple bench-top setup: the cheek riser mounts with double-sided tape or removable glue, and the standard LOP kit includes longer screws for its supplied 10 mm or 20 mm setup.

For every LOP spacer, use one spacer by default. A multi-piece stack can be used only in special cases, but it does not create the strongest possible connection and is not the recommended default. If stacking is required, glue the spacer pieces together before final installation and contact us first to confirm the locating and fastening hardware.

No drilling or permanent stock modification is required. If a screw does not start cleanly, stop and contact us before forcing it.

The cheek riser and LOP spacer kits are designed to avoid drilling or permanent stock modification. Remove parts carefully if you later change your setup.

If you are unsure about fit or installation, contact us before forcing any part.

Use the current instructions and fit limits on the exact product page before starting. If the supplied hardware, stock, pad, or locating path does not match what is shown, stop and contact us before forcing any part.

AU shipping is free on orders over A$75. International shipping is A$20 flat; tax and duties are shown at checkout before payment.

Everything is built and dispatched from Australia.

Beyond the 30-day fit guarantee, unused items in original condition can be returned per our refund policy. Get in touch and we'll sort it.

Fit your Tikka, shoot it, and if it's not right within 30 days we'll make it right. We engineer to OEM tolerances and stand behind it — the guarantee is there to take the risk out of trying something new on a rifle you care about.