Every part is designed around Tikka factory-stock fit — no "fits-most" compromises. Designed in Finland, built in Australia.
Already know what feels wrong? Go straight to the part that solves that symptom.
For low comb height and inconsistent cheek weld after a scope is fitted.
Drop Comb Cheek Riser View cheek riser → Stock feels short or crampedFor cramped trigger reach or shoulder position after eye relief is set.
LOP Spacer Kit View LOP kit → Both problems show upFor scoped Tikkas that need cheek height and stock length adjusted together.
Performance Kit Choose kit → Existing Trigger Spring questionCompatibility validation is pending. Contact us if you already have the part or an existing order.
Support Contact Nokka Tactical →Not sure yet? Use the fit checklist first.
A simple, well-made reloading block that stays where you put it. We designed this block around our own reloading workflow. Non-slip rubber...
Replacement locating shim / adapter plate for the Nokka Tikka T3/T3x/T1x LOP Spacer Kit. This is the thin plate that indexes the...
The Tikka ACE and UPR are built for precision — but factory length of pull isn't built for you. Whether you're shooting...
Most Tikka T3x (and T3 / T1x) stocks ship with a comb height that works fine with iron sights — but mount...
The Nokka Flat-Recoil LOP Spacer is a length-of-pull spacer with an angled rear face. It changes how the recoil pad sits against...
Length of pull (LOP) is one of the most overlooked variables in Tikka rifle fit. Too long and you reach for the...
Cheek height and length of pull are the two fit adjustments most likely to change how naturally a scoped Tikka mounts. The...
Takes about 2 minutes. It separates cheek height, length of pull, and scope position before you choose parts.